# Wi-Fi 6, 6E and 7 Explained: What Changes and When to Upgrade

What do Wi-Fi 6, 6E and 7 bring in practice? OFDMA, 6 GHz, MLO and 320 MHz explained clearly, plus when an upgrade makes sense and which devices support it.

Router boxes keep showing bigger numbers: Wi-Fi 6, Wi-Fi 6E, Wi-Fi 7, with theoretical speeds of tens of gigabits per second. But what do you actually notice at home? And should you replace your router every time a new standard arrives? This article explains what each generation adds in practice, where the marketing exaggerates, and when an upgrade is or isn’t worth it.

## First, the names

For some years now, the Wi-Fi Alliance has used simple generation numbers instead of the technical names:

- Wi-Fi 5 = 802.11ac (5 GHz only)

- Wi-Fi 6 = 802.11ax on 2.4 and 5 GHz

- Wi-Fi 6E = 802.11ax, extended to the 6 GHz band

- Wi-Fi 7 = 802.11be, on 2.4, 5 and 6 GHz

All generations are backwards compatible. An old laptop works fine with a new router, just with the capabilities of the older of the two.

## Wi-Fi 6: more efficient with many devices

The key improvement in Wi-Fi 6 isn’t peak speed but efficiency. In a home with dozens of devices, from phones and laptops to smart bulbs and cameras, that makes the difference.

- OFDMA: a channel is divided into smaller slices so the router can serve several devices in a single transmission. Think of a delivery van carrying parcels for several addresses rather than making a separate trip for each one. Especially with many small data flows, such as calls, gaming and smart devices, this results in lower and more stable latency.

- MU-MIMO in both directions: the router can communicate with several devices at once via multiple antennas, now also for traffic from devices to the router.

- Target Wake Time (TWT): devices agree when to wake up to exchange data, saving battery on phones and sensors.

- BSS colouring: helps identify neighbouring networks on the same channel so devices wait less unnecessarily.

- 1024-QAM: more data per signal, but only with a strong signal close to the router.

## Wi-Fi 6E: a new, quiet motorway

Wi-Fi 6E adds no new techniques, but it does add a new frequency band: 6 GHz. That’s probably the biggest practical improvement in years. In Europe, 480 MHz of spectrum is available in the 6 GHz band (5945–6425 MHz). That’s less than in some other parts of the world, but still enough for three 160 MHz channels or several 80 MHz channels.

The big advantage is that this band is clean. Older devices can’t use it, so there are no slow Wi-Fi 4 or Wi-Fi 5 devices hogging airtime, and there’s (still) little interference from neighbours. In a block of flats where the 2.4 and 5 GHz bands are packed, this can make a huge difference to stability and jitter.

The downside is that 6 GHz has shorter range and penetrates walls less well than 5 GHz. In practice it works best in the same room as the router or one room away. For whole-home coverage you’ll often need several access points or a mesh system.

## Wi-Fi 7: wider, smarter and multiple bands at once

Wi-Fi 7 builds on Wi-Fi 6E and adds several important techniques:

- Multi-Link Operation (MLO): the best-known innovation. A device can connect over several bands at the same time, for example 5 and 6 GHz, and split traffic or always use the least congested band. This can reduce latency and make the connection more robust when one band is briefly disrupted. How well MLO works still varies by device and firmware.

- 320 MHz channels: twice as wide as Wi-Fi 6E, on 6 GHz only. In Europe, with 480 MHz of spectrum, only one such channel fits, and in a busy environment such a wide channel is more susceptible to interference. For most households this is mainly a number on the box.

- 4096-QAM: even more data per signal, again only with an excellent signal at short range.

- Preamble puncturing: if part of a wide channel suffers interference, the router can skip that slice instead of falling back to a narrower channel.

## Theory versus practice

Theoretical maximums, such as 9.6 Gbps for Wi-Fi 6 and over 40 Gbps for Wi-Fi 7, assume ideal conditions and more antennas than your phone or laptop has. A typical phone or laptop achieves a fraction of that in practice. Moreover, your internet connection is often the limiting factor: on a 500 Mbps plan, a router capable of 5 Gbps over Wi-Fi makes little difference to your downloads. The real gains are in stability, lower latency when the network is busy, and better performance with many devices.

## Which devices support what?

You only benefit from a new standard if both your router and your device support it. Check the specifications of your phone, laptop or tablet. A few points to note:

- For 6 GHz, the operating system has to cooperate too. On Windows laptops, for example, Windows 11 is required, plus an up-to-date driver.

- Many smart devices, printers and older TVs support only 2.4 GHz. They’ll keep working on a new router.

- A Wi-Fi card in a desktop PC is often cheap to swap for a newer model.

## When is upgrading worth it?

Worth it:

- Your router supports only Wi-Fi 5 or older and you have many devices.

- You live in a crowded area with lots of neighbouring networks and suffer from fluctuating ping and stutters; 6 GHz can bring a lot of calm.

- You have a connection of 1 Gbps or more and want to use that speed wirelessly too.

- Your router no longer receives security updates.

Less worthwhile:

- Your devices don’t support the new standard.

- Your problem is coverage: a new router in the same spot rarely fixes a dead zone. Look at mesh or access points instead.

- Your problem lies in the internet connection itself or in bufferbloat.

## Measure before and after

Before upgrading, run a speed test over Wi-Fi and over a cable, in the same locations. If your Wi-Fi already gets close to wired speed, a new router won’t add much in terms of speed. Repeat the test after upgrading and check ping and jitter as well. The stability test shows whether the connection has become calmer over a longer period. For more general advice, see how to make Wi-Fi faster.

## In short

- Wi-Fi 6: more efficient with many devices thanks to OFDMA; a solid baseline.

- Wi-Fi 6E: the 6 GHz band is quiet and fast, but has shorter range.

- Wi-Fi 7: MLO for more stable connections; 320 MHz is of limited use in Europe.

- Router and device must both support the standard.

- Upgrade for an old router, many devices or a crowded area; not for a coverage problem.

### Measure it yourself

Speed test with bufferbloat, jitter and AI explanation. Free and ad-free.
